Krell Industries Digital to Analog Processor STUDIO 2 Manual de usuario Pagina 1

STUDIO 2O O 0 0 0 0 0 0 0STUDIO 2 DIGITAL TO ANALOG PROCESSOROWNER’S REFERENCE

CONNECTIONSHow to connect AT&T cables:a. Remove the plastic cover from the outside of the AT&Ttransmitter (located on Transport

OPERATIONINPUT SELECT SWITCHINGThe STUDIO 2 has multiple digital inputs. Each input has its owninput switch and direct path to the

OPERATION0° and 180° PHASE SWITCHINGThe absolute output phase of the STUDIO 2 can be changed. Insome recordings the master tape was

OPERATIONOPERATING INSTRUCTIONS1. Select an input with the Input switch. Notice the Signal LEDwill illuminate when the digital source

OPERATION’ " ’"NOTE: While your STUDIO 2 will perform beautifully from themoment you turn it on, it requires a minimum warm-up

QUESTIONS AND ANSWERSQ. My CD player has both fiber optic and coaxial outputs. Whichone should I use?A. Given a choice, we prefer the

QUESTIONS AND ANSWERSQ. Do I have to switch the Sampling Frequency when I go betweenmy CD and DAT?A. No. Your STUDIO 2 automatica

QUESTIONS AND ANSWERSQ. While listening to my STUDIO 2 I experience occasionalperiods of silence through my speakers. Is my Processor

SPECIFICATIONSFREQUENCY RESPONSE-.3 dB@ 20KHz and at 8HzSIGNAL TO NOISE> 115dBDIGITAL-TO-ANALOG CONVERTER18 bitPROCESSING1 Motorola DSP

WARRANTY AND SERVICEWARRANTY AND SERVICE INFORMATIONThere are no user-serviceable parts inside the STUDIO 2. TheSTUDIO 2 has a limited

INTRODUCTIONThank you for your purchase of the Krell STUDIO 2 Digital-to-Analog Processor and welcome to the Krell family of audioco

KRELL35 Higgins Drive Milford CT 06460SALES (203) 874-3139 FAX (203) 878-8373© 1993 KRELL DIGITAL(STUDIO29303)

... TABL~ OF CONTENTS4UNPACKING INSTRUCTIONS5 PLACEMENT6 AC POWER CONSIDERATIONS7 INPUT AND OUTPUT CONNECTIONSi i PROCESSOR OPERATION1

UNPACKINGUNPACKING INSTRUCTIONS1. Open the box and remove the top layer of foam. The followingitems will now be visible:STUDIO 2 D/A

PLACEMENTPLACEMENTBefore you install the STUDIO 2 into your system, we recommendthat you follow these guidelines in choosing the locat

AC POWERAC POWER CONSIDERATIONSNOTE: While the STUDIO 2 has superb regulation and does notrequire a dedicated AC circuit, we strongly

CONNECTIONSINPUT AND OUTPUT CONNECTIONSCAUTION: When making connections to this component or anyother, make sure the power amplifier is

CONNECTIONS3. The Left and Right channel RCA outputs are labeled on theback panel. The balanced outputs are not labeled. The balanc

CONNECTIONS5. Once you have completed the necessary input and outputconnections, select the input of your choice. For each inputsele