Krell Industries Digital to Analog Processor STUDIO 2 Manual de usuario descargar pdf (Pagina 9)

CONNECTIONS

5. Once you have completed the necessary input and output

connections, select the input of your choice. For each input

selected, the corresponding LED will illuminate. When a powered

digital input source and the Processor have linked, the SYNC LED

will illuminate.

DIGITAL SOURCE TO D/A PROCESSOR INTERLINK CONSID

ERATIONS

Care should be taken in selecting the type of cable used to link the

digital source to your Processor. We suggest the AT&T wide-

bandwidth fiber optic cable be used. The AT&T format has a

bandwidth of approximately 50 MegaBit. This allows accurate

transmission of the digital bit stream without data corruption

and proves to be sonically superior. If the AT&T format is not

available, a high quality quartz fiber optic cable (TOSH format)

can work well. Using a fiber optic interconnect reduces ground

loop problems often associated with quality audio systems.

If coaxial cable is used, it should be non-capacitive and have a

bandwidth in excess of 10MHz to prevent drop-out errors. For

best results with coaxial cable we recommend the AES/EBU

balanced format. The AES/EBU format is a + 5 volt balanced

digital transmission. Because of the high voltage balanced for-

mat, this system allows for accurate data transmission and has

great sonic advantages over standard single-ended coaxial or

Tosh fiber optic terminations. The AES/EBU coaxial cable must

have two conductors and a shield for balanced termination.

PAGE 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

Krell Industries Digital to Analog Processor STUDIO 2 Manual de usuario Pagina 9